Help with transfering a hand written drawing to a wireframe.

[drysonbennington]

I have a had written drawing of a Starship that I want to create a wireframe for. The drawing images are below.

http://i21.photobucket.com/albums/b285/ ... C-2140.jpg

http://i21.photobucket.com/albums/b285/ ... C-2140.jpg

http://i21.photobucket.com/albums/b285/ ... C-2410.jpg

http://i21.photobucket.com/albums/b285/ ... C-2140.jpg

I also want to take this outdated design and re-build the design from the keel up to make her a sleek and fast vessel.

Any help with this is appreciated

[Chris2005]

You mean make this into a 3d model? First off, you need to scan those drawings onto the computer, so u can make better use of them. The rest is pretty much simple.

[drysonbennington]

I would do that but the drawing is larger then it actually seem to be.

The dimensions are about three feet x 18" so that will make it a little difficult to scan in.

[drysonbennington]

I will for go the models on that desing for awhile, until I can figure a way to scan them in with out creasing the paper.

Here as some that I have scanned into the pc.

http://i21.photobucket.com/albums/b285/ ... rtview.jpg

http://i21.photobucket.com/albums/b285/ ... alview.jpg